Security Link SL150 Průvodce řešením problémů Strana 83

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 144
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 82
16–1
SECTION 16
Zone Programming
(
56/
58 Menu Mode)
••••••••••••••••••••••••••••••••••••••••••••••••••
In This Section
About Zone Programming
56 Zone Programming Procedures
58 Expert Programming Mode Procedures
To Remove a Zone
To Delete a Transmitter Serial Number
To Enter and Duplicate Wireless Keys
••••••••••••••••••••••••••••••••••••••••••••••••••
About Zone Programming
56 Zone Programming is an Interactive Menu mode that is used to program zones, zone
types, report codes, enroll 5800 RF Wireless Transmitter serial numbers, and identify the
type of loop input device(s). This mode can also be used to enter alpha descriptors for
programmed zones; however, we recommend entering descriptors in menu mode
82 (
Section
19: Alpha Descriptor Programming
after all zone programming has been completed). Refer to
the zone assignment table for
56 on the separate programming form.
The
58 Expert Programming Mode, which is a faster method of programming, is designed
for those who have had previous experience in programming control panels of this type.
56 Zone Programming Procedures
Note:
Before proceeding, you must program field
22 (RF System) and field
25 (Wired Zone
Expansion) as required.
In the programming mode, key
56.
SET
TO CONFIRM?
0 = NO 1 = YES 0
This display will appear upon entry into
56 mode. The default is
0 (No). If 1 (Yes) is entered, you will be prompted to confirm each
transmitter after entering the serial and loop numbers (at the
XMIT TO CONFIRM prompt later in this procedure). We
recommend that you confirm the programming of every
transmitter.
Enter Zn Num.
(00 = Quit) 10
Zone 10 entered
Zone Number (Zn): Enter the zone number that you wish to
program.
Zone 10 has been entered as an example in display at left.
Press [
] to continue.
Zn ZT RC In: L
10 00 10 RF:
A summary display appears, showing the status of that zone’s
programming when using wireless keys.
Note:
If hard-wired zones (01-08) are being programmed, the
display will appear as follows.
Zn ZT RC In: RT
1 00 10 HW: 1
Refer to Response Time options in the Programming Guide.
Press [
] to continue.
Zobrazit stránku 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 143 144

Komentáře k této Příručce

Žádné komentáře