Security Link SL150 Průvodce řešením problémů Strana 108

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 144
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 107
SL150 Installation and Setup Guide
20–2
SPEED
LEARN MODE
60219F#71F2F
You can enter up to 16 keystrokes to program a macro. There are
no wordspaces between entries – as indicated previously, each
individual command is separated by a terminator (pressing the “C”
key).
The keypad display echoes the keys that are pressed (see example
on the previous page which shows the progression of the keypad
display as each entry is made).
Following the entry of all commands, the full display at left will
appear.
SPEED
LEARN MODE
6
02
19
F
#71
F
2
F
At left is an explanation for each entry that has been made in our
example.
With the above entries, the “C” key can now be used to execute the following series of
commands:
Bypass zones 2 and 19, turn relay 1 on, and arm the system in the AWAY mode.
To Execute a Macro
To start a speedkey sequence, press the MACRO key (C) key.
The following display will appear:
ENTER USER CODE
Enter the 4-digit code previously assigned to the macro user (see
Section 23 – System
Operation
under “Secondary User Codes” for instructions on how to assign a user code to a
macro).
The programmed speedkey sequence will begin automatically.
NOTE:
There are two macros available per system. Each user may be assigned to execute
one of the two macros.
When defining speedkey sequences, do
NOT
use the [#] key to represent Quick Arming. The
SL150 system uses the entered code in response to the prompt to initiate commands in a
speedkey sequence, so the Quick Arm key is unnecessary. The system interprets the use of
the [#] key in a speedkey sequence as its designated function only
BYPASS
(6) key
Zone Nos.
2 & 19
Terminator
Relay 1
ON
AWAY
(2) key
TerminatorTerminator
Zobrazit stránku 107
1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 143 144

Komentáře k této Příručce

Žádné komentáře