Security Link SL150 Průvodce řešením problémů stáhnout pdf (Strana 70)

SL150 Installation and Setup Guide

15–2

✱

25 WIRED ZONE EXPANSION 0

0 = no expander module connected

1 = 4219 connected

2 = 4229 connected

3 = 4204 connected

✱

26 CHIME BY ZONE 0

0 =

(chimes on fault of any entry/exit or perimeter zone when chime mode

activated)

1 = yes (chimes on fault of specific zones programmed in relay zone list 3

when chime mode activated)

This option allows the

installer

to define the specific zones intended to chime

when faulted while the system is in chime mode.

✱

27 POWERLINE CARRIER DEVICE (X10) HOUSE ID 0

Powerline Carrier devices require a House ID. This field identifies this House

ID to the control.

Powerline

Carrier devices are used, they are selected in field

✱

80.

House ID is entered in following manner:

0 = A, 1 = B, 2 = C, 3 = D, 4 = E, 5 = F, 6 = G, 7 = H, 8 = I, 9 = J,

# + 10 = K, # + 11 = L, # + 12 = M, # + 13 = N, # + 14 = O, # + 15 = P.

✱

28 PHONE MODULE ACCESS CODE 0 | 0

1–9 = first digit of access code

[

✱

] or [#] = second digit of access code (enter [#] +11 for “

✱

”, or [#] +12 for “#”)

The use of a 4285/4286 VIP Module requires a 2-digit code.

Example: If desired access code is 7

✱

, 7 is the first entry, and # + 11 (for

✱

) is

the second entry.

Note: A “0” in either digit disables the phone module.

✱

29 OUTPUT TO LONG RANGE RADIO (No. 7720PLUS/7820) 0

If output to Long Range Radio (LRR) is selected here, all messages that are

programmed to go to the primary telephone line receiver will also be sent to

the 7720PLUS or 7820 radio. These messages will always be in Contact ID

format (not affected by entry in field

✱

48). The data line and certain functions

in the radio are supervised. If communication is lost or a trouble develops, an

attempt will be made to send a message via both radio and telephone to the

Central Station.

NOTE: Normal "Trouble Restore" report (

✱

71) is sent upon restoration of the

condition.

Entry is first digit of "Trouble Dialer" report; enter Trouble code 1–9,

A (# + 10), B (# +11), C (# +12), D (# +13), E (# +14), or F (# +15). The second

digit of "Trouble Dialer" report is automatically the second digit from field

✱

60.

UL installations: Must be 0 (Long Range Radio disabled)

NOTE: The radio should be programmed for device address 3 on the keypad

lines.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 143 144

Komentáře k této Příručce

Žádné komentáře

Security Link SL150 Průvodce řešením problémů Strana 70

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Security Link SL150