Security Link SL150 Průvodce řešením problémů stáhnout pdf (Strana 10)

SL150 Installation and Setup Guide

1–2

Security Codes

• One Installer code for entire system (user 1)

•One Master code

for entire system

(user 2)

• 12 Secondary User

codes

(users 3–14)

• One Babysitter code (user 15).

• One Duress Code (user 16).

Baby-sitter Code:

A special code that can only be used to disarm the system if that particular

code (or the installer code) was used to arm it. Generally assigned to a babysitter or cleaner.

Duress Code:

An emergency code that, when entered by

any

user, will send a silent duress

message to the Central Station.

Note:

A report code must be programmed otherwise it will be

reported as user 16 only.

Keypad Panic Keys

• Up to 3 programmable panic key pairs provided

• Designated as zones 95, 96, 99

• Activated by wired and wireless keypads

• Distinguished by subscriber ID number.

Zone Monitor Features

• The control will sense a high resistance or short in the loops on hardwired zones

2–8 if present, and will display a trouble (CHECK) message (rather than an alarm)

for the affected zone when the system is in the disarmed mode. The system cannot

be armed as long as this condition is present.

• Also sends a Trouble message to the Central Station when the system is in the

disarmed mode.

Exit Error False Alarm Prevention Feature

• Enables the system to determine the difference between an actual alarm and an

alarm caused by leaving an entry/exit or interior zone open after the Exit Delay

expires. If not disarmed in time, an alarm will sound and an Exit Error report will

be sent to the Central Station.

An exit alarm condition will also occur if an entry/exit or interior zone re-opens

within 2 minutes after the end of an Exit Delay.

Exit Restart Feature

•

The system contains an Exit Restart feature which allows the user to restart the

exit delay at any time when arming in the STAY or INSTANT modes by simply

pressing the [

✱] key. This is useful if the user wishes to open the entry/exit door to

let someone in after arming the system, and avoids having to disarm the system

and then re-arm it again. This feature allows only one restart of the exit delay

time for each arming session.

This feature will be enabled when an “8” or greater

value is entered in field

✱

91.

Optional Output Relays and Powerline Carrier Devices (X10 type)

• Maximum of 4 Output Devices

• Up to 4 relays using one

4204

Relay Module

•

Up to 2 relays using one 4229 Zone Expansion/Relay Module

• Up to 8 Powerline Carrier devices (you must subtract the number of relay outputs

actually used by the 4204 or 4229 modules, if used)

• Actions programmable to respond to zone activity or manual keypad entries.

Powerline Carrier devices require the use of the optional 4300 Transformer Module instead of the

supplied 1321 AC Transformer.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 143 144

Komentáře k této Příručce

Žádné komentáře

Security Link SL150 Průvodce řešením problémů Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Security Link SL150