Security Link SL150 Uživatelská příručka stáhnout pdf (Strana 29)

- 29 -

Security Codes

General Information

As an additional safety feature, other users who do not need to know your code

can be assigned different security codes. These secondary users are identified

by "user numbers," which you select when you assign a user's security code.

You can assign up to 14 additional user codes (user numbers 03-16), including

the babysitter and Duress codes. Note that the master (primary) user of the

system is the only one who can assign codes to secondary users. The master (or

primary user of the system) is user number 02; user number 01 is reserved for

the installer of the system.

All codes can be used interchangeably when performing system functions (a

system armed with one user's code can be disarmed by another user's code),

except the special codes, described below.

Babysitter Code

This code can be used to arm the system, but cannot disarm the system unless

the system was armed with this code. It is typically assigned to someone (such

as a babysitter) who needs to arm/disarm the system only at certain times. The

babysitter code is assigned to user 15. The user of this code should

not

use the

Quick Arming feature described later.

Duress Code

This feature is intended for use when you are forced to disarm or arm the

system under threat. When used, the system will operate normally, but can

silently notify the alarm monitoring company of your situation, if that service

has been provided. The Duress code is assigned to user 16. Ask your installer if

this has been programmed in your system. If so, place a check in the box to the

left.

Important:

This code is useful only when the system is connected to an alarm

monitoring company.

If Duress code is programmed in your system, enter a check in box at left.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 59 60

Žádné komentáře

Security Link SL150 Uživatelská příručka Strana 29